• One pair (red, black) of small, insulated, nickel plated jaws
• Blunt tip grabs round screw heads up to 9.5 mm
• Recommended for use with TL222 and TL224 test leads

Fluke AC280 SureGrip™ Hook Clips

• One pair (red, black) of nickel plated clips
• Profile narrows to 5.6 mm at tip, hook opening 6.4mm at front, 2 mm at base
• Recommended for use with TL222 and TL224 test leads

• One pair (red, black) of nickel plated pincers open to 5 mm
• 11.4 cm flexible insulated shaft
• Recommended for use with TL222 and TL224 test leads

• One pair (red, black) of large alligator clips with nickel-plated steel jaws
• Multi-purpose tooth pattern grips anything from fine gauge wire to a 20 mm bolt
• Recommended for use with TL222 and TL224 test leads.

 Fluke AC87 Heavy Duty Bus Bar Clip Set

• One pair (red, black) of flat, right angle design for connecting to bus bars
• Adjustable collar provides 2 ranges of jaw openings up to 30 mm

• One pair (red, black) of large alligator clips with nickel-plated steel jaws
• Alligator clip jaws providing an 8 mm opening with flexible boots
• Recommended for use with TL71 ,TL75 ,TL175  and TP175 test leads.

• Single probe pierces 0.25 to 1.5 mm insulated wire
• Small pin allows self-healing of the insulation
• 1000 V, 10 A maximum

• Banana jack accepts all DMM and banana jack leads
• Non-rotating banana jack prevents leads from tangling, allowing you to tighten/loosen clamp while still connected to the test lead
• For use with test leads with 4 mm plugs
• Tested to 60 V DC.

• Banana jack accepts all DMM and banana jack leads
• Non-rotating banana jack prevents leads from tangling, allowing you to tighten/loosen clamp while still connected to the test lead
• For use with test leads with 2 mm probes
• Tested to 60 V DC